LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2148 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test F: The Tachometer Is Inoperative >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The PCM uses the Crankshaft Position (CKP) sensor to measure the engine RPM and sends the Instrument Cluster (IC) data over the High Speed Controller Area Network (HS-CAN) communication bus to command the tachometer gauge according to the data.

If the IC  does not receive the engine RPM data from the PCM for 5 seconds or less, the IC  defaults the tachometer to the last setting, based upon the last known good RPM message. If the IC  does not receive the engine RPM data from the PCM for more than 5 seconds or if the data received is deemed invalid, the IC  sets DTC U0100 in continuous memory and defaults the tachometer to 0 RPM.

NOTE: If DTC U0100 is set in the IC  , other observable symptoms may be an inoperative speedometer, temperature gauge or odometer.

This pinpoint test is intended to diagnose the following: 

scientia non olet · About LEMON Manuals