LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2137 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Installation

Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory drive belt tensioner and the 3 bolts.
    • Tighten to 11 Nm (97 lb-in).
    2. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
  3. Install the RH inner fender splash shield. For additional information, refer to FRONT END BODY PANELS .
scientia non olet · About LEMON Manuals