LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2098 (Windows And Glass - Glass, Frames And Mechanisms) >> Removal & Installation >> Window Glass - Rear Door >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM & ORNAMENTATION article.
  2. Remove the interior weatherstrip.
  3. Position the watershield aside.
  4. Remove the nut and the exterior weatherstrip.
  5. Connect the battery. For additional information, refer to BATTERY, MOUNTING & CABLES article.
  6. Connect the window control switch electrical connectors.
  7. Lower the window glass to gain access to the rear door window glass rivets.
    8. CAUTION: Prior to removing rivet center pins, it is necessary to place a suitable block support between the door outer panel and the rear door window channel bracket to stabilize the rear door window glass during rivet removal.
  8. Remove the rear door window glass rivets.
  9. Lower the window glass to the full down position.
  10. Remove the glass from the division bar, move the glass between the division bar and the door outer panel and remove the rear door window glass.
  11. To install, reverse the removal procedure.
    • Using the special tool, install the new rivets.
scientia non olet · About LEMON Manuals