LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2098 (Windows And Glass - Glass, Frames And Mechanisms) >> Removal & Installation >> Window Glass - Front Door >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM & ORNAMENTATION article.
  2. Remove the front door speaker. For additional information, refer to INFORMATION & ENTERTAINMENT SYSTEMS article.
  3. Remove the 2 screws, release the locking tab and position the driver door module (DDM) aside.
  4. Position the watershield aside.
  5. Remove the interior weatherstrip.
  6. Connect the window control switch electrical connectors.
    7. Fig 1: Window Control Switch Electrical Connectors
    GF0018619Courtesy of FORD MOTOR CO.
  7. Lower the door window glass to gain access to the rivets.
    8. CAUTION: Prior to removing the rivet center pins, it is necessary to place a suitable block support between the door outer panel and the door window channel bracket to stabilize the door window glass during rivet removal.
  8. Remove the front door window glass rivets.
    9. Fig 2: Door Window Glass Rivets
    GF0018620Courtesy of FORD MOTOR CO.
  9. Remove the front door window glass.
  10. To install, reverse the removal procedure.
    • Using the Heavy Duty Riveter, install the new rivets.
scientia non olet · About LEMON Manuals