LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1648 (Anti-Theft System - Passive Anti-Theft System (Pats)) >> Removal & Installation >> Passive Anti-Theft System (Pats) Transceiver >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition lock cylinder. For additional information, refer to HANDLES, LOCKS, LATCHES & ENTRY SYSTEMS article.
    2. NOTE: If necessary, use a suitable tool to gently pry the 2 locking tabs outward far enough to release the transceiver from the steering column.
  2. Disconnect the electrical connector and remove the PATS transceiver.
    3. NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the PCM again.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals