Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

All vehicles

Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .

Vehicles with power seats

Disconnect the seat position sensor electrical connector.
Remove the seat position sensor bolt.
- To install, tighten to 9 Nm (80 lb-in).
Remove the seat position sensor.
- Press the sensor tab inward to release and remove the seat position sensor.
Remove the magnet assembly bolt.
- To install, tighten to 9 Nm (80 lb-in).
Remove the magnet assembly.
- Slide the magnet assembly rearward to release the front tab to remove the magnet assembly.

Vehicles with manual seats

Disconnect the seat position sensor electrical connector.
Remove the bolt and the seat position sensor.
- To install, tighten to 9 Nm (80 lb-in).

All vehicles

To install, reverse the removal procedure.
Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .