LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt Idler Pulley >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. For additional information, refer to Accessory Drive Belt  .
  2. Remove the bolt and the accessory drive belt idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
    3. Fig 1: Accessory Drive Belt Idler Pulley
    GF0013750Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals