Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Disconnect the ignition coil electrical connectors.
Remove the ignition coil bolts.
- To install, tighten to 5 Nm (44 lb-in).

NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.

Remove the ignition coils.

Early build vehicles (black coil boot)

NOTE: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.

NOTE: Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.

NOTE: Refer to SPECIFICATIONS for correct spark plug identification.

Remove the spark plugs.
- To install, tighten to 34 Nm (25 lb-ft).

Late build vehicles (brown coil boot)

NOTE: Only use hand tools when removing or installing the spark plugs, or damage may occur to the cylinder head or spark plug.

NOTE: Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.

NOTE: Refer to the SPECIFICATIONS for correct spark plug identification.

Remove the spark plugs.
- To install, tighten to 12 Nm (9 lb-ft).
To install, reverse the removal procedure.
- Apply a light film of silicone brake caliper grease and dielectric compound to the inside of the coil boots before installation.