LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Safety Belt System) >> Removal And Installation >> Child Safety Seat Tether Anchor - LATCH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. For additional information, refer to SEATING article.
  2. Remove the 2 lower anchors and tethers for children bolts.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the lower anchors and tethers for children attachment.
    • When installing, make sure the lower anchors and tethers for children is positioned with the locator pin going through the hole provided in the lower anchors and tethers for children attachment.
    4. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals