LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1531 (Electronic Engine Control) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor - 4.6L (3V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the intake manifold. For additional information, refer to ENGINE - 4.6L (3V) .
  4. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  5. Remove and discard the CHT sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  6. To install, reverse the removal procedure.
    • Do not reuse the CHT sensor, install a new sensor.
scientia non olet · About LEMON Manuals