LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Exterior Lighting System) >> Removal And Installation >> Headlamp Assembly >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.

Aerodynamic 

  1. Remove the 3 bolts and the headlamp assembly.
    • Disconnect the electrical connectors.

    2. Sealed beam 

  2. Remove the side lamp/front turn signal lamp. For additional information, refer to Side Lamp/Front Turn Signal Lamp Bulb .
  3. Remove the 4 screws and the headlamp retaining ring.
  4. Remove the headlamp assembly.
    • Disconnect the electrical connector.

    5. All headlamp types 

  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals