Pinpoint Test C: One High Beam Headlamp Is Inoperative
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE:
Make sure the headlamp bulb is good before continuing diagnostics.
- C1 CHECK THE LOW BEAM OPERATION
- Check the operation of the low beams.
- Do the low beams operate correctly?
- YES : REPAIR circuit CLF08 (YE/VT) for an open. TEST the system for normal operation.
- NO : Go to Pinpoint Test B .