Pinpoint Test D: All Door Locks Are Inoperative From One Switch
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- D1 CHECK THE DOOR LOCK CONTROL SWITCH
- Disconnect: Inoperative Door Lock Control Switch
- Carry out the door lock control switch component test. Refer to appropriate COMPONENT TESTING article.
- Is the door lock control switch OK?
- YES : REPAIR circuit GD182 (BK/GY) for an open. TEST the system for normal operation.
- NO : INSTALL a new door lock control switch. REFER to Door Lock Control Switch . TEST the system for normal operation.