Fluorescent Dye Injection - Using a Dye Injector Loop Kit

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Fluorescent refrigerant system dye is added to the refrigerant system at the factory to assist in refrigerant system leak diagnosis using a Rotunda-approved ultraviolet blacklight. It is not necessary to add additional dye to the refrigerant system before diagnosing leaks, even if a significant amount of refrigerant has been removed from the system. Additional refrigerant system dye should only be added if more than 50% of the refrigerant system lubricant capacity has been lost due to a fitting separation, hose rupture or other damage.

NOTE: Before using the R-134a fluorescent dye injector for the first time, refer to the equipment manufacturers instructions on evacuation of non-condensable gasses from the hoses.

NOTE: Refrigerant system pressure should be between 413-551 kPa (60-80 psi) at 24°C (75°F).

Verify that the valves on the deluxe injector loop kit are closed.

Fig 1: Identifying Valves On Fluorescent Dye/Lubricant Injector

Courtesy of FORD MOTOR CO.

Fill the deluxe injector loop kit reservoir with 7 ml (0.25 oz.) of fluorescent dye.

Fig 2: Identifying Deluxe Injector Loop Kit Reservoir

Courtesy of FORD MOTOR CO.

Install the deluxe injector loop kit between the high-pressure and low-pressure service gauge port valves.

CAUTION: Make sure all tools and hoses are clear of the engine cooling fan and drive belt before starting the engine.

Start the engine.
Open the high-pressure service valve.

Fig 3: Identifying High-Pressure Service Valve

Courtesy of FORD MOTOR CO.

Open the deluxe injector loop kit valves and inject the fluorescent dye into the refrigerant system.

Fig 4: Locating Valves On Deluxe Injector Loop Kit

Courtesy of FORD MOTOR CO.

Close the high-pressure service valve to allow the pressure inside the deluxe injector loop kit to equalize with the suction side of the refrigerant system.

Fig 5: Identifying High-Pressure Service Valve

Courtesy of FORD MOTOR CO.

NOTE: Close the valves on the deluxe injector loop kit while the A/C compressor is operating.

Close the valves on the deluxe injector loop kit.

Fig 6: Locating Valves On Deluxe Injector Loop Kit

Courtesy of FORD MOTOR CO.

NOTE: Leave all valves on the special tool closed when not in use.

Disconnect the high-pressure and low-pressure service valves and remove the deluxe injector loop kit from the vehicle.