LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Steering Column Switches) >> Removal And Installation >> Ignition Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the supplemental restraints system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
    2. NOTE: Release the upper steering column shroud by pressing inward on the sides and lifting upwards.
  2. Remove the upper steering column shroud.
  3. Release the tilt lever, remove the 3 lower steering column shroud screws and the shroud.
    4. NOTE: The top of the steering column opening cover is held in by tabs that clip into the instrument panel.
  4. Remove the 2 steering column opening cover screws.
    • Detach the steering column opening cover by pulling straight outward.
  5. If equipped, disconnect the electrical connector and hose from the in-vehicle temperature sensor.
    • Remove the steering column opening cover.
  6. Disconnect the ignition switch electrical connector.
  7. Press the 2 locking tabs and remove the ignition switch.
  8. To install, reverse the removal procedure.
  9. Repower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
scientia non olet · About LEMON Manuals