LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1102 (Instrument Cluster System) >> Diagnostic Tests >> Instrument Cluster (IC) >> Pinpoint Tests >> Pinpoint Test W: The O/D Off Indicator Is Never/Always On >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

The instrument cluster receives the overdrive (O/D) off signal from the PCM over the high speed controller area network (HS-CAN) communication bus. When the O/D function is selected off, the PCM sends a message to the instrument cluster to illuminate the O/D off indicator. If the speed control message is missing or if the data is deemed invalid by the instrument cluster for more than 5 seconds, the instrument cluster sets DTC U0100 in continuous memory and defaults the O/D off indicator off.

NOTE: If DTC U0100 is set in the instrument cluster, other observable symptoms may be an inoperative speedometer, tachometer or odometer.

Possible Causes

scientia non olet · About LEMON Manuals