LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1090 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Installation

Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory drive belt tensioner and the 3 bolts.
    • Tighten to 11 Nm (8 lb-ft).
    2. NOTE: After installation, make sure the belt is correctly seated on all pulleys.
  2. Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
  3. Install the RH inner fender splash shield. For additional information, refer to FRONT END BODY PANELS
scientia non olet · About LEMON Manuals