Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

RH sensor

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .

Both sensors

Disconnect the heated oxygen sensor (HO2S) electrical connector.

NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.

Using the special tool, remove the heated oxygen sensor (HO2S).
- To install, tighten to 48 Nm (35 lb-ft).

Fig 1: Removing Heated Oxygen Sensor (HO2S) Using Special Tool (303-476)

Courtesy of FORD MOTOR CO.

NOTE: Apply a light coat of anti-seize lubricant to the threads of the heated oxygen sensor (HO2S).

To install, reverse the removal procedure.