LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKS FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel & Console >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

  1. Tilt the steering wheel to the full downward position.
  2. Remove the 2 steering column opening trim panel screws.
  3. Remove the steering column opening trim panel.
    • Pull the steering column opening trim panel rearward to release the retaining clips.
  4. Remove the LH instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - LH .
  5. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER .
  6. Remove the ignition switch bezel.
  7. Remove the 4 headlamp switch screws.
  8. Remove the headlamp switch.
    • Disconnect the electrical connector.
  9. Remove the 2 instrument cluster finish panel screws.
  10. Remove the instrument cluster finish panel.
  11. To install, reverse the removal procedure.
    • Transfer parts as needed.
    • To install, make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.
scientia non olet · About LEMON Manuals