LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKS FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, & Warning Chimes >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

  1. Place the ignition in the RUN mode (do not start the engine).
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
  3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.

    To disable the seating position, buckle then unbuckle the safety belt 9 times, ending in the unbuckled state.

    • After Step 3, the safety belt warning indicator illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
    • This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the restraint system warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the restraint system warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the restraint system warning indicator flashing 4 times per second for 3 seconds again.
scientia non olet · About LEMON Manuals