LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> MKS FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Electrical Compass - Electronic Compass >> General Procedures >> Compass Zone Adjustment

Compass Zone Adjustment

  1. NOTE: This procedure is only applicable to vehicles without navigation. For vehicles with navigation, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .

    Refer to the compass calibration zone map to select the correct compass zone setting for the geographic location of the vehicle.

    Fig 1: Compass Calibration Zone Map
    G06076691Courtesy of FORD MOTOR CO.
  2. With the ignition in the ON position, press and hold the 7 and 9 buttons (for approximately 5 seconds) until the compass display shows the current zone setting (ZONE XX). Release the 7 and 9 buttons.
  3. NOTE: After approximately 5 seconds, the compass display exits the zone setting mode after the 7 and 9 buttons have been released.

    Before the zone setting mode turns off (within 5 seconds), momentarily press and release the 7 and 9 buttons to increase the zone increment by one. Set the zone display number to match the vehicle geographical location on the compass calibration zone map.

  4. Release the 7 and 9 buttons for 5 seconds to exit the zone setting mode.
scientia non olet · About LEMON Manuals