LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2008 >> Navigator 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster (Ic), Message Center, And Warning Chimes >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

  1. Position the IC and install the 4 screws.
    • Connect the electrical connector.
  2. Position the IC finish panel and install the ambient air temperature sensor electrical connector and air tube.
  3. Connect the dimmer switch electrical connector.
  4. Install the IC finish panel and the 2 screws.
  5. Position the lower steering column cover and install the 3 screws.
    • Connect the electrical connector for the brake pedal switch (if equipped).
  6. If installing a new IC, upload the IC configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article, PMI.
    7. NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM results in a no start condition.
    NOTE: If equipped, the vehicle's Passive Anti-Theft System (PATS) keys must be programmed to the new IC.
  7. Carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals