LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2007 >> Navigator RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center >> General Procedures >> Compass Zone Adjustment - Without Message Center

Compass Zone Adjustment - Without Message Center

  1. Determine which magnetic zone you are in for your geographic location.
    2. Fig 1: Compass Calibration Zone Map
    G03965509Courtesy of FORD MOTOR CO.
  2. Start the engine.
  3. Locate the reset button on the top of the compass module at the base of the interior rear view mirror.
    4. Fig 2: Identifying Reset Button
    GF0004498Courtesy of FORD MOTOR CO.
  4. Press and hold the reset button for 6 seconds and release when ZONE appears in the instrument cluster display.
    5. NOTE: The zone selection increases with each subsequent button press with a range of zones from 1 to 15 scrolling back to the beginning.
  5. Press and release the reset button until the desired zone number appears.
  6. When the desired zone number appears in the instrument cluster display, do not press the reset button. The instrument cluster locks in the zone setting and returns to normal operation when the reset button is not pressed for approximately 4 seconds.
scientia non olet · About LEMON Manuals