LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2007 >> MKZ FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster >> Removal And Installation >> Instrument Cluster >> Removal

Instrument Cluster: Removal

All vehicles 

NOTE: When installing a new instrument cluster, it is necessary to upload the module configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION , programmable module installation (PMI).
  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Tilt the steering column to the lowest position.

    3. MKZ 

  3. Remove the 2 instrument cluster finish panel screws and the instrument cluster finish panel.
  4. Remove the 2 screws and the instrument cluster.
    • Disconnect the electrical connector.

    5. Fusion, Milan 

    NOTE: The instrument cluster finish panel is held in place by spring clips located on the finish panel.
  5. Remove the instrument cluster finish panel.
    6. NOTE: The top of the instrument cluster is a snap fit to the instrument panel. To ease removal of the instrument cluster insert a suitable tool between the instrument panel and the top of the instrument cluster and use a slight outward movement until the top of the instrument cluster is released. The instrument cluster can now be rotated outwards.
  6. Remove the 2 screws and the instrument cluster.
    • Disconnect the electrical connector.
scientia non olet · About LEMON Manuals