LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2007 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - 5.4L (3V) - F250-F550 Super Duty) >> In-Vehicle Repair >> Engine Support Insulators >> Installation

Engine Support Insulators: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    RH engine mount 

    CAUTION: Clean the engine mount bracket-to-cylinder block mating surfaces of any dirt or foreign material prior to installation.
  1. Position the RH engine mount bracket and install the 4 bolts.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 1: Cleaning Engine Mount Bracket
      G03920165Courtesy of FORD MOTOR CO.
    2. CAUTION: Clean the engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
  2. Position the RH engine mount and install the 4 bolts.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 2: Positioning RH Engine Mount
      G03920168Courtesy of FORD MOTOR CO.

    3. LH engine mount 

    CAUTION: Clean the engine mount-to-oil filter adapter and engine mount-to-chassis mating surfaces of any dirt or foreign material prior to installation.
  3. Position the LH engine mount and install the 3 bolts.
    • Tighten to 63 Nm (46 lb-ft).
      Fig 3: Positioning LH Engine Mount
      G03920166Courtesy of FORD MOTOR CO.

    4. All vehicles 

  4. Lower the engine into position.
    5. CAUTION: Only use hand tools when installing the RH engine mount nut or damage to the engine mount can occur.
    NOTE: RH shown, LH similar.
  5. Install the 6 engine mount nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 4: Identifying Engine Mount Nuts
      G03919938Courtesy of FORD MOTOR CO.
    6. CAUTION: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
  6. Install the transmission mount-to-crossmember nuts.
    • Tighten to 103 Nm (76 lb-ft).
      Fig 5: Identifying Transmission Mount-To-Crossmember Nuts
      G03963913Courtesy of FORD MOTOR CO.
  7. Position the Y-pipe and install the 4 nuts.
    • Tighten to 40 Nm (30 lb-ft).
      Fig 6: Locating Exhaust Manifold-To-Catalytic Converter Nuts
      G03920889Courtesy of FORD MOTOR CO.
  8. Remove the special tools.
    Fig 7: Installing Special Tools
    G04647876Courtesy of FORD MOTOR CO.
  9. If installing the RH engine mount, install the starter. For additional information, refer to STARTER MOTOR .
  10. Install the upper cooling fan shroud. For additional information, refer to COOLING FAN -- BLADE, CLUTCH AND SHROUD .
  11. Install the generator. For additional information, refer to GENERATOR -- GASOLINE ENGINES .
  12. Install the air cleaner housing. For additional information, refer to AIR CLEANER -- 5.4L (3V) .
  13. Connect the battery ground cable.
scientia non olet · About LEMON Manuals