LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2007 >> MKX FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - 5.4L (3V) - F250-F550 Super Duty) >> Disassembly And Assembly Of Subassemblies >> Piston >> Assembly

Disassembly And Assembly Of Subassemblies: Piston: Assembly

WARNING: This page is about a different car, the 2005 Ford Pickup and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The connecting rod must be installed into the piston with identification markings toward the front.
  1. Position the connecting rod in the piston.
  2. Lubricate the piston pin and pin bore with clean engine oil.
  3. Install the piston pin in the piston and connecting rod assembly.
  4. Install the piston pin retaining clips in the piston.
  5. Lubricate the piston and the new piston rings with clean engine oil.
  6. Install the piston rings onto the piston.
    Fig 1: Locating Identification Mark
    G03885869Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals