Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Steering Column Multifunction Switch Remove/Install Components

Courtesy of FORD MOTOR CO.

Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .

Fig 2: Removing Ignition Switch Lock Cylinder
Courtesy of FORD MOTOR CO.
Remove the ignition switch lock cylinder.
1. Insert the ignition key into the lock cylinder and turn the ignition switch to the RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
If equipped, twist the tilt wheel handle and remove it.
Remove the screws and the steering column shrouds.
Remove the screws and the multi-function switch.
- To install, tighten to 3 Nm (27 lb-in).
Disconnect the multi-function switch electrical connectors.
To install, reverse the removal procedure.
Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .