LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2006 >> Navigator RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Electronic Engine Control System - 6.0L (99P E Series & 99P F450/550) Diesel Engine - F250-F550 Super Duty) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the manifold absolute pressure (MAP) sensor.
    • Disconnect the pressure hose.
    • Disconnect the electrical connector.
    3. Fig 1: Locating Manifold Absolute Pressure Sensor Electrical Connector
    GF0006053Courtesy of FORD MOTOR CO.
  3. Remove the mounting screws and the MAP sensor.
    4. Fig 2: Locating MAP Sensor & Mounting Screws
    GF0006054Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals