Engine Coolant Temperature (ECT) Sensor: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Apply clean engine oil to the new O-ring seal prior to installation.

Using a new O-ring seal, install the ECT sensor.
- Tighten to 18 Nm (13 lb-ft).
Connect the ECT sensor electrical connector.
Connect the cooling fan electrical connector.

Fig 1: Locating Cooling Fan Electrical Connector

Courtesy of FORD MOTOR CO.

Fill and bleed the engine cooling system. For additional information refer to ENGINE COOLING article.