Solenoid Body: Disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the manual valve.

Fig 1: Locating Manual Valve

G03889343

Courtesy of FORD MOTOR CO.

Remove and discard the solenoid body electrical connector O-ring seal.

Fig 2: Locating Solenoid Body Electrical Connector O-Ring Seal

G03889078

Courtesy of FORD MOTOR CO.

Remove the main control valve body electrical harness.
- Remove the 2 bolts.
- Disconnect the electrical connectors.
- Lift the tab and twist and push the bulkhead connector through the solenoid body.
- Remove the solenoid body electrical harness.

Fig 3: Locating Main Control Valve Body Electrical Harness

G03889345

Courtesy of FORD MOTOR CO.

NOTE: Mark the location of each solenoid for correct installation.

Remove the E-clips and remove the solenoids.

Fig 4: Locating Shift Solenoids With E-Clips

G03889346

Courtesy of FORD MOTOR CO.

Remove the transmission fluid temperature (TFT) sensor by lifting the tab and rotating counterclockwise.

Fig 5: Locating Transmission Fluid Temperature (TFT) Sensor

G03889347

Courtesy of FORD MOTOR CO.

Note the location and length of each bolt. Remove the 4 bolts and remove the top half of the main control valve body.

Fig 6: Locating Main Control Valve Body Bolts

GF0006893

Courtesy of FORD MOTOR CO.

NOTE: The gasket should not be cleaned or reused.

Remove and discard the gasket.

Fig 7: Identifying Filter Screen Gasket

G03889349

Courtesy of FORD MOTOR CO.

Remove the bolts, backing plate and discard the gasket. Clean and inspect the components.

Fig 8: Identifying Backing Plate Bolts

GF0006894

Courtesy of FORD MOTOR CO.