LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2005 >> LS 3.0 S >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster >> Removal And Installation >> Warning Indicator Bulb >> Removal and Installation

Removal and Installation

  1. Remove the instrument cluster. For additional information, REFER to INSTRUMENT CLUSTER  in this article.
  2. Remove the 5 screws and the rear cover.
    Fig 1: Removing Screws And Rear Cover
    G03998339Courtesy of FORD MOTOR CO.
  3. Remove the 6 screws and position the circuit board aside.
    Fig 2: Removing Circuit Board Screws
    G03998340Courtesy of FORD MOTOR CO.
    4. NOTE: To remove a warning indicator bulb, rotate the bulb one quarter turn counterclockwise and lift it straight out from the instrument cluster.
    Fig 3: Removing Warning Indicator Bulb
    G03998341Courtesy of FORD MOTOR CO.
  4. Remove the warning indicator bulb in question.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals