LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2004 >> Navigator 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Four Wheel Drive (4WD) Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Prior to removal of the 4 wheel drive (4WD) control module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Open and lower the glove box compartment.
  3. Disconnect the connectors from the four wheel drive (4WD) control module.
    Fig 1: Locating Four Wheel Drive (4WD) Control Module Connector
    G04650799Courtesy of FORD MOTOR CO.
  4. Remove 2 nuts and the 4WD control module.
    Fig 2: Locating 4WD Control Module Nuts
    G04650800Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals