Brake Booster: Installation

Install the power brake booster.

Fig 1: Installing Power Brake Booster
Courtesy of FORD MOTOR CO.
Install the booster nuts.

Fig 2: Installing Power Brake Booster Nuts
Courtesy of FORD MOTOR CO.
Install the brake pedal pin.

Fig 3: Installing Power Brake Pedal Pin
Courtesy of FORD MOTOR CO.
Install the clip on the brake pedal pin.

Fig 4: Installing Brake Pedal Pin Clip
Courtesy of FORD MOTOR CO.
Install the radiator coolant recovery reservoir bolts.

Fig 5: Installing Coolant Recovery Reservoir Bolts
Courtesy of FORD MOTOR CO.
Connect the coolant reservoir hose.

Fig 6: Connecting Coolant Reservoir Hose
Courtesy of FORD MOTOR CO.
Connect the power brake booster electrical connector (as applicable).

Fig 7: Connecting Power Brake Booster Electrical Connector
Courtesy of FORD MOTOR CO.
Connect the power brake booster check valve.

Fig 8: Connecting Power Brake Booster Check Valve
Courtesy of FORD MOTOR CO.
Connect the coolant reservoir return hose.

Fig 9: Connecting Coolant Reservoir Return Hose
Courtesy of FORD MOTOR CO.
Install the brake master cylinder. For additional information, see MASTER CYLINDER .
Install the cowl brace end bolts.

Fig 10: Installing Cowl Brace End Bolts
Courtesy of FORD MOTOR CO.
Install the cowl brace center bolts.

Fig 11: Installing Cowl Brace Center Bolts
Courtesy of FORD MOTOR CO.
Install the vacuum hose bracket nut.

Fig 12: Installing Vacuum Hose Bracket Nut
Courtesy of FORD MOTOR CO.
Install the cowl cover.
1. Install the cowl cover.
2. Install the cowl cover rubber trim.
3. Install the cowl cover pushpins.
  
  Fig 13: Installing Cowl Cover
  Courtesy of FORD MOTOR CO.
Connect the washer hose.

Fig 14: Connecting Washer Hose
Courtesy of FORD MOTOR CO.
Install the wiper arm nuts.

Fig 15: Installing Wiper Arm Nuts
Courtesy of FORD MOTOR CO.
Bleed brake system. For additional information, see BLEEDING BRAKE SYSTEM .
Check the coolant level. Fill as necessary. For additional information, see ENGINE COOLING.