All vehicles
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- If equipped, remove the overhead console.
- Release the locking tabs while pulling down.
- Remove the left and right screws and visors.
- If equipped, disconnect the electrical connector.
- Position the left and right front door opening weatherstrips down from the headliner.
- Remove the left and right A-pillar trim panel. For additional information, refer to A-Pillar Trim Panel in this article.
- Remove the courtesy lamp lens, then remove the screws.
NOTE:
SuperCab shown, regular cab similar.
- Remove both of the left and right safety belt guides.
- Position the shoulder safety belt guide cover up.
- Remove the shoulder safety belt guide nut.
- To install, tighten to 40 N.m (30 lb-ft).
- Remove the shoulder safety belt guide.
- Remove the left and right coat hooks.
- Remove the assist handle.
- Remove the covers and bolts.
- Remove the assist handle.
- Position aside the B-pillar trim panels.
- Remove the 2 headliner front pin-type retainers.
- Remove the headliner.
- To install, reverse the removal procedure.