LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2001 >> Continental >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (Evaporative Emissions - (Hybrid)) >> Removal And Installation >> Fuel Vapor Vent Valve >> Installation

Fuel Vapor Vent Valve: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel vapor vent valve onto the EVAP canister bracket.
  2. Connect the fuel vapor tube quick connect coupling to the fuel vapor vent valve. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  3. Install the EVAP canister assembly. For additional information, refer to Evaporative Emission Canister .
  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  5. Carry out the EVAP system leak test. For additional information, refer to Evaporative Emission System Leak Test .
  6. Carry out the EVAP repair verification drive cycle. For additional information, refer to INTRODUCTION -- HYBRID ENGINES article.
scientia non olet · About LEMON Manuals