LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> Navigator 4WD >> Repair and Diagnosis >> Suspension >> Front Suspension - 4WD Torsion Bar - Expedition, F150 Pickup & Navigator >> Removal & Installation >> Hub & Bearing Assembly >> Installation

Hub & Bearing Assembly: Installation

  1. Using Bearing Cup Replacer (T80T-4000-P), Knuckle Seal Replacer (T96T-1175-A) and Threaded Drawbar (T77F-1176-A), install seal until it seats against steering knuckle. Install hub and bearing assembly onto steering knuckle, guiding CV axle shaft through spline in hub. Tighten hub and bearing assembly-to-steering knuckle mounting bolts to specification. See TORQUE SPECIFICATIONS .
  2. Align marks, and install brake rotor and caliper. With brakes applied, tighten hub retainer nut to specification. See TORQUE SPECIFICATIONS . Install washer, nut lock and NEW cotter pin. DO NOT back off nut to install cotter pin. To complete installation, reverse removal procedure. Reactivate air suspension system. Before driving vehicle, pump brake pedal several times to restore normal pedal position.
scientia non olet · About LEMON Manuals