LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> LS 3.9 A >> Repair and Diagnosis >> External Pages >> Different car >> Section 914 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Gearmotor Encoder Assembly >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the mode select switch to the 4 High (4H) position.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  3. Disconnect the gearmotor encoder assembly harness connectors.
    Fig 1: Locating Gearmotor Encoder Assembly Harness Connectors
    G04650813Courtesy of FORD MOTOR CO.
  4. Remove the 3 gearmotor encoder bolts and the gearmotor encoder assembly.
    • To install, tighten to 20 Nm (15 lb-ft).
      Fig 2: Locating Gearmotor Encoder Bolts
      G04650814Courtesy of FORD MOTOR CO.
  5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new adapter as necessary.
  6. To install, reverse the removal procedure.
    • Apply a coat of grease to the new motor adapter.
scientia non olet · About LEMON Manuals