LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> LS 3.9 A >> Repair and Diagnosis >> External Pages >> Different car >> Section 1278 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Turbine Shaft Speed (TSS) Sensor And Intermediate Shaft Speed Sensor >> Installation

Turbine Shaft Speed (TSS) Sensor And Intermediate Shaft Speed Sensor: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TSS and intermediate shaft speed sensor.
    • Lubricate the O-ring with clean automatic transmission fluid and install the TSS and intermediate shaft speed sensor.
    • Install the bolt.
      • Tighten to 9 Nm (80 lb-in).
    2. Fig 1: Identifying Intermediate Shaft Speed Sensor
    GF0006803Courtesy of FORD MOTOR CO.
  2. Connect the TSS and intermediate shaft speed sensor electrical connector.
    3. Fig 2: Identifying Intermediate Shaft And Turbine Shaft Combination Speed Sensor Electrical Connector
    G03889065Courtesy of FORD MOTOR CO.
  3. Raise the transmission into position.
  4. Position the crossmember to the transmission insulator and retainer, and loosely install the nut.
    5. Fig 3: Locating Crossmember To Transmission Mount Nut
    G03889185Courtesy of FORD MOTOR CO.
  5. Install the LH crossmember bolts.
    • Tighten to 81 Nm (60 lb-ft).
      • Fig 4: Locating LH Crossmember Bolts
      GF0005601Courtesy of FORD MOTOR CO.
  6. Install the RH crossmember bolts.
    • Tighten to 81 Nm (60 lb-ft).
      • Fig 5: Identifying RH Crossmember Bolts And Nuts
      G03920816Courtesy of FORD MOTOR CO.
  7. Install the bracket and loosely install the bolts.
    • Install the bracket.
    • Loosely install the bolts.
      • Fig 6: Identifying Bracket And Bolts
      GF0006804Courtesy of FORD MOTOR CO.
  8. Tighten the RH crossmember bolts.
    • Tighten to 81 Nm (60 lb-ft).
      • Fig 7: Identifying RH Crossmember Bolts
      GF0006805Courtesy of FORD MOTOR CO.
  9. Tighten the transmission insulator and retainer nuts.
    • Tighten to 103 Nm (76 lb-ft).
      • Fig 8: Identifying Transmission Support Insulator Nuts
      G03889099Courtesy of FORD MOTOR CO.
  10. Install the wire harness and install the 2 retaining clips to the rear of the crossmember.
    11. Fig 9: Locating Wire Harness At Rear Of Crossmember
    G03908863Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals