Disassembly And Assembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Individual parts of the planet assemblies are not repairable.

Remove the lube slinger.

Fig 1: Locating Lube Slinger

Courtesy of FORD MOTOR CO.

Remove the No. 12 forward clutch thrust bearing.

Fig 2: Removing Forward Clutch Thrust Bearing

Courtesy of FORD MOTOR CO.

Remove the No. 11 thrust bearing.

Fig 3: Locating No. 11 Thrust Bearing

Courtesy of FORD MOTOR CO.

Inspect the forward planet assembly.
- The pins and shafts in the plant assemblies should be checked for loose fit or damage. Use a new planet assembly if either condition exists.
- Inspect the pinion gears for damaged or excessively worn teeth.
- Check for free rotation of the pinion gears.

Fig 4: Inspecting Forward Planet Assembly

Courtesy of FORD MOTOR CO.

To assemble, reverse the disassembly procedure.
- Lightly lubricate the thrust bearings with petroleum jelly to hold them in place during assembly.
- The No. 12 thrust bearing must be installed with the notched inner race facing outward.