LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> Continental >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> System Tests >> Test K: Low Washer Fluid Warning Never/Always On

Test K: Low Washer Fluid Warning Never/Always On

  1. Ensure washer reservoir is full. Turn ignition switch to OFF position. Disconnect washer fluid level sensor harness connector. Turn ignition switch to RUN position. If washer warning is on, go to next step. If washer warning is not on, go to step  3 .
  2. Turn ignition switch to OFF position. Measure resistance between ground and Black wire terminal at washer fluid level sensor harness connector. If resistance is 5 ohms or less, go to step  4 . If resistance is greater than 5 ohms, repair open in Black wire.
  3. Disconnect instrument cluster harness connector C256. Measure resistance in Pink/Yellow wire between washer fluid level sensor harness connector and terminal No. 17 at instrument cluster harness connector C256. See Figure . If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Pink/Yellow wire.
  4. Measure resistance between washer fluid level sensor terminals (component side). If resistance is greater than 5 ohms, replace washer fluid level sensor. If resistance is 5 ohms or less, replace instrument cluster.
scientia non olet · About LEMON Manuals