Test J: Charge Warning Never/Always On
- Check charging system operation. See appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS. If charging system is operating properly, go to next step. If charging system is not operating properly, repair as necessary.
- Turn ignition switch to RUN position. If charging warning indicator is not on, go to next step. If charging warning indicator is on, go to step 4 .
- Turn ignition switch to OFF position. Disconnect instrument cluster harness connector C256. Disconnect generator voltage regulator harness connector C154. Measure resistance in Light Green/Red wire between generator voltage regulator harness connector C154 and terminal No. 18 at instrument cluster harness connector C256. See Figure . If resistance is 5 ohms or less, replace instrument cluster. If resistance is greater than 5 ohms, repair open in Light Green/Red wire.
- Turn ignition switch to OFF position. Disconnect instrument cluster harness connector C256. Disconnect generator voltage regulator harness connector C154. Measure resistance between ground and Light Green/Red wire terminal at generator voltage regulator harness connector C154. If resistance is greater than 10 k/ohms, replace instrument cluster. If resistance is 10 k/ohms or less, repair short to ground in Light Green/Red wire.