Fuel Gauge

Disconnect fuel level sensor and fuel pump harness connector located at fuel tank. Connect one lead of Instrument Gauge Tester (014-R1063) to Yellow/White wire terminal of harness connector and other lead to ground. Set tester to 22.4 ohms. Turn ignition on. Wait one minute. Fuel gauge should read EMPTY. Turn ignition off. Set tester to 145 ohms. Turn ignition on. Wait one minute. Fuel gauge should read FULL. If gauge tests as described, replace fuel level sensor and fuel pump assembly. If gauge does not test as described, go to TEST D: FUEL GAUGE INOPERATIVE.