Removal & Installation (Except Crown Victoria, Grand Marquis, Town Car and Mark VIII)
- Remove front brake caliper and pads. See FRONT BRAKE CALIPER & PADS . If caliper does not require service, DO NOT remove brake hose from caliper.
- Secure caliper aside. Remove rotor from hub assembly. If rotor is difficult to remove, spray rust penetrant on front and rear of rotor/hub mating surfaces.
- Using a plastic hammer, strike rotor between studs. If rotor is still difficult to remove, use a 3-jawed puller. To install rotor, reverse removal procedure. Bleed brakes. See BLEEDING BRAKE SYSTEM .