LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1997 >> Continental >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Electronic Air >> Removal & Installation (Front Suspension - Mechanical) >> SUBFRAME >> Installation

Removal & Installation (Front Suspension - Mechanical): SUBFRAME: Installation

  1. Align subframe with body. Ensure all rubber mounts are in position. Install, but DO NOT  tighten, NEW subframe bolts.
  2. Install a 3/4" O.D. pipe into driver-side subframe and body alignment holes. Alignment holes are located near front subframe bolts. Slightly tighten left front subframe bolt.
  3. Repeat step 2) on right side (passenger) alignment holes. After verifying subframe is aligned, tighten subframe bolts to specification. See TORQUE SPECIFICATIONS  .
  4. To complete installation, reverse removal procedure. Use NEW ball joint nuts. Tighten fasteners to specification. Lower vehicle, and turn air suspension on.
scientia non olet · About LEMON Manuals