Headlight Switch R & I
WARNING:
Before repairing or removing any items on vehicles with air bags, see SAFETY PRECAUTIONS in STEERING COLUMN SWITCHES article.
- Disconnect negative battery cable. Insert hooked tool into slot-hole at base of headlight-switch knob to depress retaining spring clip and pull knob off shaft. See Fig 1-6. Remove dimmer knob/trim bezel from shaft.
- Remove left and right instrument panel horizontal trim moldings to allow access to cluster finish panel lower retaining screws. Remove all cluster finish panel retaining screws and remove panel.
- Remove headlight switch bracket-to-instrument panel screws. Pull bracket, with switch attached, from panel and disconnect switch harness connector. Remove switch lock nut to remove switch from bracket. To install, reverse removal procedure.