Front Suspension Removal & Installation: SUBFRAME: Installation
- Align subframe with body. Ensure all rubber mounts are in position. Install, but DO NOT tighten new subframe bolts.
- Install a 3/4" O.D. pipe into driver's side subframe and body alignment holes. Alignment holes are located near front subframe bolts. Slightly tighten left front subframe bolt.
- Repeat step 2) on right side (passenger) alignment holes. After verifying subframe is aligned, tighten subframe bolts to specification. See TORQUE SPECIFICATIONS table.
- To complete installation, reverse removal procedure. Use new ball joint pinch bolt. Tighten fasteners to specification. See TORQUE SPECIFICATIONS table. Lower vehicle and turn on air suspension switch.
CAUTION:
DO NOT turn air suspension switch on until vehicle is lowered and vehicle weight exists on all wheels.