LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1987 >> Mark VII Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [F] & 5.0L Ho V8 - VIN [M] >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

  1. Disconnect negative battery cable and drain cooling system. Remove carburetor air inlet tube. Remove fan shroud and position shroud over fan. Remove fan and spacer from water pump shaft. Remove shroud and all accessory drive belts.
  2. Remove all accessory brackets attached to water pump. Remove water pump pulley. Disconnect radiator lower hose, heater hose and water by-pass hose at water pump. Remove bolts that attach water pump to front cover. Remove pump and discard gasket.
NOTE: If installing new water pump, transfer pulley from old pump.
scientia non olet · About LEMON Manuals