LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1987 >> Mark VII Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [F] & 5.0L Ho V8 - VIN [M] >> Overhaul >> Cylinder Block: Fitting Piston Pins >> Removal

Cylinder Block: Fitting Piston Pins: Removal

  1. Remove bearing inserts from connecting rod and cap. Mark pistons, pins and inserts (if reusable) to assure assembly with same rod. Press piston pin from piston and connecting rod using arbor press and Piston Pin Remover/Replacer (T68P-6135-A).
  2. Inspect and replace any piston pin showing signs of fracture, etching or wear. Check piston pin-to-rod bore fit. Lubricate pin and small end of rod bore with engine oil.
scientia non olet · About LEMON Manuals