LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1987 >> Mark VII Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [F] & 5.0L Ho V8 - VIN [M] >> Overhaul >> Cylinder Block: Camshaft Bearings >> Removal

Cylinder Block: Camshaft Bearings: Removal

  1. With camshaft, flywheel and crankshaft removed from engine, push pistons to top of cylinders. Remove camshaft rear bearing bore plug. Using Camshaft Bearing Driver/Puller (T65L-6250-A), remove camshaft bearings.
  2. During inner bearing removal, wrap cloth around threads of puller to protect front bearing or journal. To remove front bearing, install puller from rear of cylinder block.
CAUTION: Failure to use correct size expanding collet during camshaft bearing installation can cause severe bearing damage. Ensure front bearing is installed at specified distance from front face of cylinder block.
scientia non olet · About LEMON Manuals