LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 1979 >> Mark V >> Repair and Diagnosis >> Electrical >> Body Electrical >> Sun & Moon Roofs - Electric >> Removal & Installation >> Sliding Panel, Halo Moulding Or Sun Shade >> Removal (Ford Motor Co. - Halo Moulding)

Removal (Ford Motor Co. - Halo Moulding)

  1. If equipped with moon roof, halo moulding must first be removed. Push sun shade to rear and open roof panel half way. Remove screws on forward portion of moulding.
  2. On Lincoln and Mark V, lower front edge of halo moulding and cycle sliding panel fully closed. Turn halo moulding sideways and down to remove.
  3. On all models except Lincoln & Mark V, cycle roof to a nearly closed position. Pull the forward center of halo moulding downward until the horizontal tabs are removed from track.
    NOTE: Place a shop towel over front horizontal tabs to prevent them from tearing headliner.

    Cycle roof to fully closed position. Slide moulding forward. Pull rearward on center section so horizontal track slide is removed from track. Slide halo moulding forward and out.

scientia non olet · About LEMON Manuals